1977 Ford L800 Recall | The Seat Belts On The Involved Vehicles Fail To Conform To Federal Motor Vehicle Safety Standard Nos. 208, “occupant Crash Protection”, And 209, “seat Belt Assemblies”. The Non-conformity Exists Because

Rate this post

1977 Ford L800 Seat Belts,front,anchorage Recall | Oct 25, 1977

The Seat Belts On The Involved Vehicles Fail To Conform To Federal Motor Vehicle Safety Standard Nos. 208, “occupant Crash Protection”, And 209, “seat Belt Assemblies”. The Non-conformity Exists Because When The Driver”s Seat Is Adjusted To The Full Forward Position, The Seat Cushion Is Adjusted To Maximum Elevation, And The Seat Back Is Tilted To The Fully Upright Position, The Seat Belts Are Not Long Enough To Accommodate Some Drivers.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Replace Any Seat Belt Assembly That Is Determined To Be Insufficient, Without Charge To Owner.
vehicle Description: Heavy Trucks Equipped With Bostrom “levelaire” Or National”cushion Aire” Adjustable Driver Seats And Standard Seat Belts.system: Interior; Seat Belt Assemblies.consequences Of Defect: In The Event Of An Accident, Lack Of Seat Beltprotection Could Result In Serious Injury To The Driver.

This recall was issued on Oct 25, 1977 for 1977 Ford L800, manufactured by FORD MOTOR COMPANY, in response to Seat Belts,front,anchorage problems.

Leave a Reply

Your email address will not be published. Required fields are marked *


*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>