2012 Ford FUSION Steering Rack And Pinion problems & defects.

Rate this post

If you are driving a 2012 Ford FUSION, or if you are planning to purchase one, then it is important that you review reported Steering Rack And Pinion problems and defects. Total reports: 2.

Multi Function Screen Showed Power Steering Malfunction At Stop Light. Vehicle Restarted And Warning Was Gone And Steering Was Normal. Next Day Warning Appeared While Driving On A Straight Road, Steering Was Very Difficult. Vehicle Pulled Over, Restarted And Warning Was Gone, Normal Steering. In One Hour It Happened Again, Vehicle Was Brought To Local ford Dealer, And The First Diagnosis Was Unknown As “codes” Did Not Indicate Steering Problem. Today They Called And Stated The Car Needs An Entire Rack And Pinion Steering Set Replacement. Unfortunately There Is A National Back Log And No Parts Available. Car Is Inoperable. Working With ford Customer Care Solutions Center For Resolution. *js

Mileage was 17000 miles. Vehicle Identification Number (VIN):3FAHP0JA8CR. FORD FUSION 2012 problem was reported in ST.PAUL, MN. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. Vehicle had 4 CYLINDERS. FORD FUSION 2012 drive type:FWD. FUEL SYSTEM:Fuel injection. FUEL TYPE: GAS. VEHICLE SPEED: 45 mph.

May 01, 2012

The Contact Owns A 2012fordfusion. The Contact Stated That The Steering Wheel Became Difficult To Turn. The Contact Mentioned That The Power Steering And Low Tire Pressure Warning Lights Illuminated. The Vehicle Was Taken To A Mechanic Where It Was Diagnosed That The Rack And Pinion Needed To Be Replaced. The Manufacturer Was Made Aware Of The Failure. The Failure And Current Mileage Was 56,000.

0 person(s) were injured. 0 person(s) died. Mileage was 56000 miles. Vehicle Identification Number (VIN):3FAHP0HA7CR. FORD FUSION 2012 problem was reported in RANCH CUCAMONGA, CA. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control.

June 25, 2014

1 Response

  1. Sandra Foster July 20, 2017 / 12:55 pm

    I have a ford fusion 2012 vin#3FAHPOHA3CR372731 power steering rack pinion after two own it . Took it to a repair shop bad power steering rack pinion.

Leave a Reply

Your email address will not be published. Required fields are marked *


*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>