1980 Ford P600 Recall | Some Of The Subject Vehicles May Have Been Built With Front Wheel Brake Hoses That Are Too Long. This May Make It Possible For The Brake Hose To Contact A Front Tire During A

1980 Ford P600 Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings Recall | Dec 23, 1980

Some Of The Subject Vehicles May Have Been Built With Front Wheel Brake Hoses That Are Too Long. This May Make It Possible For The Brake Hose To Contact A Front Tire During A Full Left Or Right Turn, Which Could Result In Chafing Of The Brake Hose And Subsequent Brake Fluid Leakage.. Follwoing Is The Summary Of Corrective Actions Taken: Vehicles Will Be Inspected And, If Necessary, Front Brake Hoses And Brackets Will Be Replaced At No Charge.
vehicle Description: Trucks.system: Service Brakes; Brake Hoses (front).consequences Of Defect: Brake Fluid Leakage May Cause A Total Loss Of Servicebrakes And A Vehicle Accident, Especially In Situations Where Minimum Stoppingdistance Is Required.note: Increased Pedal Travel And Sponginess In The Brake Pedal Are Warningindicators Of Brake Fluid Leakage.

This recall was issued on Dec 23, 1980 for 1980 Ford P600, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings problems.

1980 Ford F250 Recall | Certain Vehicles Were Not Equipped With A Front Protective Shield For The Mid-ship Fuel Tank. These Vehicles Do Not Comply With Federal Motor Vehicle Safety Standard No. 301, “fuel System Integrity”.

1980 Ford F250 Fuel System, Gasoline,storage,tank Assembly Recall | Apr 10, 1980

Certain Vehicles Were Not Equipped With A Front Protective Shield For The Mid-ship Fuel Tank. These Vehicles Do Not Comply With Federal Motor Vehicle Safety Standard No. 301, “fuel System Integrity”. In The Event Of A Frontal Collision, Excessive Fuel Spillage May Occur.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect And, If Necessary, Install The Required Mid-ship Fuel Tank Shield, Without Charge To Owner.
vehicle Description: Light Trucks (4×2 And 4×4).system: Fuel; Mid-ship Fuel Tank Shield.consequences Of Defect: Fuel Spillage Following An Accident Could Result In Avehicle Fire And Personal Injury To Passengers.

This recall was issued on Apr 10, 1980 for 1980 Ford F250, manufactured by FORD MOTOR COMPANY, in response to Fuel System, Gasoline,storage,tank Assembly problems.

1980 Ford F150 Recall | Certain Vehicles Were Not Equipped With A Front Protective Shield For The Mid-ship Fuel Tank. These Vehicles Do Not Comply With Federal Motor Vehicle Safety Standard No. 301, “fuel System Integrity”.

1980 Ford F150 Fuel System, Gasoline,storage,tank Assembly Recall | Apr 10, 1980

Certain Vehicles Were Not Equipped With A Front Protective Shield For The Mid-ship Fuel Tank. These Vehicles Do Not Comply With Federal Motor Vehicle Safety Standard No. 301, “fuel System Integrity”. In The Event Of A Frontal Collision, Excessive Fuel Spillage May Occur.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect And, If Necessary, Install The Required Mid-ship Fuel Tank Shield, Without Charge To Owner.
vehicle Description: Light Trucks (4×2 And 4×4).system: Fuel; Mid-ship Fuel Tank Shield.consequences Of Defect: Fuel Spillage Following An Accident Could Result In Avehicle Fire And Personal Injury To Passengers.

This recall was issued on Apr 10, 1980 for 1980 Ford F150, manufactured by FORD MOTOR COMPANY, in response to Fuel System, Gasoline,storage,tank Assembly problems.

1980 Ford Ltd Recall | Misbuilt Wiring Harnesses May Have Been Installed On Certain Vehicles. This Would Allow The Power Windows To Be Operated While The Ignition Key Is Turned Off, A Condition Which Fails To Comply With

1980 Ford Ltd Visibility,power Window Devices And Controls Recall | May 16, 1980

Misbuilt Wiring Harnesses May Have Been Installed On Certain Vehicles. This Would Allow The Power Windows To Be Operated While The Ignition Key Is Turned Off, A Condition Which Fails To Comply With Federal Motor Vehicle Safety Standard No. 118, “power Operated Window Systems”.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect The Wiring Harness And Repair, If Necessary.
vehicle Description: Passenger Vehicles.system: Visual; Power Windows.consequences Of Defect: Accident And Injury Could Result If Children Are Ableto Operate Power Windows Without Adult Supervision.

This recall was issued on May 16, 1980 for 1980 Ford Ltd, manufactured by FORD MOTOR COMPANY, in response to Visibility,power Window Devices And Controls problems.

1980 Ford Club Wagon Recall | Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete

1980 Ford Club Wagon Wheels,center Section Recall | June 09, 1980

Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete Separation Of The Wheel And Tire Assembly From The Vehicle.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect The Wheel Disc Date Code And Replace Those Wheels Indicating An October 18, 1979 Date Of Manufacture.
vehicle Description: Light Trucks.system: Wheels; Wheel Assemblies.consequences Of Defect: Separation Of The Wheel Assembly Could Cause Loss Ofvehicle Control And An Accident.note: The Driver May Be Warned Of The Condition By Wheel Wobble Or Vibration.

This recall was issued on June 09, 1980 for 1980 Ford Club Wagon, manufactured by FORD MOTOR COMPANY, in response to Wheels,center Section problems.

1980 Ford E Series Recall | Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete

1980 Ford E Series Wheels,center Section Recall | June 09, 1980

Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete Separation Of The Wheel And Tire Assembly From The Vehicle.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect The Wheel Disc Date Code And Replace Those Wheels Indicating An October 18, 1979 Date Of Manufacture.
vehicle Description: Light Trucks.system: Wheels; Wheel Assemblies.consequences Of Defect: Separation Of The Wheel Assembly Could Cause Loss Ofvehicle Control And An Accident.note: The Driver May Be Warned Of The Condition By Wheel Wobble Or Vibration.

This recall was issued on June 09, 1980 for 1980 Ford E Series, manufactured by FORD MOTOR COMPANY, in response to Wheels,center Section problems.

1980 Ford Econoline Recall | Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete

1980 Ford Econoline Wheels,center Section Recall | June 09, 1980

Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete Separation Of The Wheel And Tire Assembly From The Vehicle.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect The Wheel Disc Date Code And Replace Those Wheels Indicating An October 18, 1979 Date Of Manufacture.
vehicle Description: Light Trucks.system: Wheels; Wheel Assemblies.consequences Of Defect: Separation Of The Wheel Assembly Could Cause Loss Ofvehicle Control And An Accident.note: The Driver May Be Warned Of The Condition By Wheel Wobble Or Vibration.

This recall was issued on June 09, 1980 for 1980 Ford Econoline, manufactured by FORD MOTOR COMPANY, in response to Wheels,center Section problems.

1980 Ford F Series (light) Recall | Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete

1980 Ford F Series (light) Wheels,center Section Recall | June 09, 1980

Certain Vehicles Were Produced With Wheel Assemblies That May Have Cracks Near The Bolt Holes In The Wheel Disc. During Vehicle Use, The Cracks Could Gradually Increase And Result In Partial Or Complete Separation Of The Wheel And Tire Assembly From The Vehicle.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect The Wheel Disc Date Code And Replace Those Wheels Indicating An October 18, 1979 Date Of Manufacture.
vehicle Description: Light Trucks.system: Wheels; Wheel Assemblies.consequences Of Defect: Separation Of The Wheel Assembly Could Cause Loss Ofvehicle Control And An Accident.note: The Driver May Be Warned Of The Condition By Wheel Wobble Or Vibration.

This recall was issued on June 09, 1980 for 1980 Ford F Series (light), manufactured by FORD MOTOR COMPANY, in response to Wheels,center Section problems.

1980 Ford E250 Recall | Due To Computer Input Error Which Resulted In An Incorrect Build Schedule, Some Vehicles Were Shipped Without The Required Exhaust System Heat Shields. When The Vehicle Is Idled Over An Extended Period Of

1980 Ford E250 Engine And Engine Cooling,exhaust System Recall | July 14, 1980

Due To Computer Input Error Which Resulted In An Incorrect Build Schedule, Some Vehicles Were Shipped Without The Required Exhaust System Heat Shields. When The Vehicle Is Idled Over An Extended Period Of Time, A Missing Exhaust Heat Shield May Result In Dangerously High Floor Pan Temperatures.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Install Frame-mounting Heat Shields Without Charge To Owner.
vehicle Description: Trucks (vans) Equipped With 300 Or 302 Cid Engines.system: Exhaust; Heat Shields.consequences Of Defect: This Could Result In Personal Injury To Passengers Orheat Damage To Items Stored On The Floor Of The Vehicle.

This recall was issued on July 14, 1980 for 1980 Ford E250, manufactured by FORD MOTOR COMPANY, in response to Engine And Engine Cooling,exhaust System problems.

1980 Ford E150 Recall | Due To Computer Input Error Which Resulted In An Incorrect Build Schedule, Some Vehicles Were Shipped Without The Required Exhaust System Heat Shields. When The Vehicle Is Idled Over An Extended Period Of

1980 Ford E150 Engine And Engine Cooling,exhaust System Recall | July 14, 1980

Due To Computer Input Error Which Resulted In An Incorrect Build Schedule, Some Vehicles Were Shipped Without The Required Exhaust System Heat Shields. When The Vehicle Is Idled Over An Extended Period Of Time, A Missing Exhaust Heat Shield May Result In Dangerously High Floor Pan Temperatures.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Install Frame-mounting Heat Shields Without Charge To Owner.
vehicle Description: Trucks (vans) Equipped With 300 Or 302 Cid Engines.system: Exhaust; Heat Shields.consequences Of Defect: This Could Result In Personal Injury To Passengers Orheat Damage To Items Stored On The Floor Of The Vehicle.

This recall was issued on July 14, 1980 for 1980 Ford E150, manufactured by FORD MOTOR COMPANY, in response to Engine And Engine Cooling,exhaust System problems.