1996 Ford Crown Victoria Recall | The Ignition Switch Could Experience An Internal Short Circuit.

1996 Ford Crown Victoria Electrical System,ignition Recall | Apr 25, 1996

The Ignition Switch Could Experience An Internal Short Circuit.this Condition Could Cause Overheating, Smoke, And Possibly Fire In The Steering Column Area Of The Vehicle.. Follwoing Is The Summary Of Corrective Actions Taken: Dealers Will Replace The Ignition Switch.
system: Electrical; Ignition Switch. Vehicle Description: Passenger And Multi-purpose Vehicles And Light Duty Trucks. Note: Owners Who Take Their Vehicles To An Authorized Dealer On An Agreed Upon Service Date And Do Not Receive The Free Remedy Within A Reasonable Time, Should Contact Ford At 1-800-392-3673. Also Contact The National Highway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.

This recall was issued on Apr 25, 1996 for 1996 Ford Crown Victoria, manufactured by FORD MOTOR COMPANY, in response to Electrical System,ignition problems.

1996 Ford Crown Victoria Recall | When In The Secondary Latched Position, The Driver Door Latches May Open When Subjected To Transverse Loads Less Than That Specified In Fmvss No. 206, “door Locks And Door Retention Components.”

1996 Ford Crown Victoria Latches/locks/linkages,doors,latch Recall | Apr 22, 1996

When In The Secondary Latched Position, The Driver Door Latches May Open When Subjected To Transverse Loads Less Than That Specified In Fmvss No. 206, “door Locks And Door Retention Components.”the Driver’s Door, When Closed Only To The Secondary Latched Position, May Not Sustain A 1,000 Pound Transverse Load.. Follwoing Is The Summary Of Corrective Actions Taken: Dealers Will Inspect And, If Necessary, Replace The Driver Door Latch.
vehicle Description: Passenger, Multi-purpose Vehicles And Mini-vans.note: Owners Who Take Their Vehicles To An Authorized Dealer On An Agreed Upon Service Date And Do Not Receive The Free Remedy Within A Reasonable Time, Should Contact Ford At 1-800-392-3673. Also Contact The National Highway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.

This recall was issued on Apr 22, 1996 for 1996 Ford Crown Victoria, manufactured by FORD MOTOR COMPANY, in response to Latches/locks/linkages,doors,latch problems.

1996 Ford Crown Victoria Recall | The Pitman Arms Were Not Fully Lubricated At The Assembly Plant. The “ball Joint” At The Outer End Of The Pitman Arm Can Become Contaminated And Corrode.

1996 Ford Crown Victoria Steering,linkages Recall | July 18, 1996

The Pitman Arms Were Not Fully Lubricated At The Assembly Plant. The “ball Joint” At The Outer End Of The Pitman Arm Can Become Contaminated And Corrode.such Corrosion Can Result In Abnormal Wear Of The Joint, Resulting In Separation Of The Joint. Loss Of Steering Control Can Occur Increasing The Risk Of A Vehicle Accident.. Follwoing Is The Summary Of Corrective Actions Taken: Dealers Will Inspect The Vehicles And If The Joint Is Found To Have Significant Wear, The Arm Will Be Replaced. Those Pitman Arms Not Replaced Will Have The “ball Joint” Fully Greased.
system: Steering; Linkages; Arm; Pitman. Vehicle Description: Police Interceptors, Commercial Fleet, Taxi, Limousines, Or Livery/trailer Tow Packages. Owner Notification: Owner Notification Is Expected To Begin August 19, 1996. Note: Owners Who Take Their Vehicles To An Authorized Dealer On An Agreed Upon Service Date And Do Not Receive The Free Remedy Within A Reasonable Time Should Contact Ford At 1-800-392-3673. Also Contact The National Highway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.

This recall was issued on July 18, 1996 for 1996 Ford Crown Victoria, manufactured by FORD MOTOR COMPANY, in response to Steering,linkages problems.

1996 Ford Crown Victoria Recall |

1996 Ford Crown Victoria Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings Recall | Mar 13, 1996

. Follwoing Is The Summary Of Corrective Actions Taken: Dealers Will Inspect The Rear Brake Lines, And If Necessary, Replace A Section Of The Rear Brake Lines If It Is Leaking. Also The Rubber Shield On The Line Will Be Inspected To Verify That It Is Properly Located And It Will Be Secured With An Additional Worm-drive Type Clamp.
system: Brakes; Hydraulic; Lines; Hose; Non-metallic. Vehicle Description: Non-abs Equipped Police Vehicles. Description Of Problem: This Is Not A Safety Recall In Accordance With Federal Regulation 573. However, It Is Deemed A Safety Improvement Campaign By The Agency. The Rear Brake Line Can Come Into Contact With A Body Weld Flange At The Lower Dash Panel During Pursuit Or Slalom Type Police Maneuvers.consequence Of Problem: This Condition Can Wear A Small Hole In The Brake Linecausing Gradual Brake Fluid Leakage Eventually Resulting In The Loss Of Therear Service Brakes.note: Ford Has Decided To Conduct A Safety Improvement Service Campaign Toinspect The Brake Lines On These Police Vehicles. Owners Can Contact Fordat 1-800-392-3673.

This recall was issued on Mar 13, 1996 for 1996 Ford Crown Victoria, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings problems.

1996 Ford Crown Victoria Recall | The Rivets Holding The Rear Outboard Belt D-rings Were Not Heat Treated Properly Causing The Heads Of The Rivets To Fracture Under Load And Fail To Hold The D-rings To The Straps. This Does

1996 Ford Crown Victoria Seat Belts,front,anchorage Recall | Mar 05, 1996

The Rivets Holding The Rear Outboard Belt D-rings Were Not Heat Treated Properly Causing The Heads Of The Rivets To Fracture Under Load And Fail To Hold The D-rings To The Straps. This Does Not Conform To The Requirements Of Fmvss No. 210, “seat Belt Assembly Anchorages.”consequence Of Non-compliance: This Condition Can Reduce The Restraining Capabilities Of The Safety Belt In The Event Of An Accident.. Follwoing Is The Summary Of Corrective Actions Taken: Dealers Will Install A Reinforcement Plate On The Rear Outboard Seat Belt Assembly Anchorages Involved In This Campaign.
system: Interior; Restraint; Belt Anchor And Attachment; Fmvss No. 210.vehicle Description: Passenger Vehicles.note: Owners Who Take Their Vehicles To An Authorized Dealer On An Agreed Upon Service Date And Do Not Receive The Free Remedy Within A Reasonable Time, Should Contact Ford At 1-800-392-3673. Also Contact The National Highway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.

This recall was issued on Mar 05, 1996 for 1996 Ford Crown Victoria, manufactured by FORD MOTOR COMPANY, in response to Seat Belts,front,anchorage problems.