1971 Ford B7000 Recall |

1971 Ford B7000 Service Brakes, Hydraulic,power Assist,vacuum Recall | Feb 19, 1971

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No H-73.f,b,c,ln-500-750, 6000-7000 & C-l 800- 900 Seriestrucks Equipped With Frame Mounted Brake Booster. Possibility That Improperlymachined Brake Booster May Have Be En Installed, Which Could Result Ininsufficient Seal At Hydra Ulic End Cap.if This Condition Exists, Hydraulicbrake Fluidleaks Would Gradually Deplete Brake Fluid Reserve Resulting I Ncomplete Loss Of Hydraulic Brake System On Vehicles Equippedwithsinglehydraulic Seal Where Necessary).necessary.eabl

This recall was issued on Feb 19, 1971 for 1971 Ford B7000, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,power Assist,vacuum problems.

1972 Ford B7000 Recall |

1972 Ford B7000 Parking Brake,driveline,hydraulic,hoses, Lines/piping, And Fittings Recall | Dec 27, 1972

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No H6e.bus Chassis.possibility That Parking Brake Systemplastic Air Brake Tube May Have Been Improperly Routed In Area Of Exhaust Tailpipe At Rear Crossmember Of Frame.if Condition Exists, Could Cause Tube Tomelt, Resulting In Automatic And Unexpected Loss Of Air Pressure And Rear Brakeapplication.(correct By Inspecting And Rerouting Brake Tube).

This recall was issued on Dec 27, 1972 for 1972 Ford B7000, manufactured by FORD MOTOR COMPANY, in response to Parking Brake,driveline,hydraulic,hoses, Lines/piping, And Fittings problems.

1974 Ford B7000 Recall |

1974 Ford B7000 Service Brakes, Air,supply,hoses, Lines/piping, And Fittings Recall | Dec 02, 1974

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No 147.bus Chassis And Trucks.possibility That Trucksequipped With Air Brakes May Have Been Inadvertently Built With An Air Supplyline From The Foot Treadle Valve To The Air Supply Tank That Could Becomedisconnected.should This Occur, The Air Supply Tank Pressure Would Beexhausted And The Service Brake System Could Not Be Activated.(correct Byinspecting And Installing Inserts Where Missing And Tighten Tube Nuts Tospecification).

This recall was issued on Dec 02, 1974 for 1974 Ford B7000, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Air,supply,hoses, Lines/piping, And Fittings problems.

1973 Ford B7000 Recall |

1973 Ford B7000 Service Brakes, Air,supply,check Valve Recall | Feb 16, 1973

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No H-7e.bus Chassis.possibility That The Double Vacuum Tanksfor Brake Booster Assemblies May Have A Vacuum Check Valve Reversedduringinstallation.if This Condition Exists And Is Left Uncorrected It Could Resultin Reduced Braking Effectiveness.(correct By Inspecting And Replace Tankswhere Necessary.)

This recall was issued on Feb 16, 1973 for 1973 Ford B7000, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Air,supply,check Valve problems.

1977 Ford B7000 Recall | The Involved Vehicles May Have Been Assembled With Improperly Manufactured Front Spring U-bolts Used To Secure The Front Axle Assembly To The Spring. The Four U-bolts May Experience Cracks And Could Ultimately Break.

1977 Ford B7000 Suspension,front,springs,leaf Spring Assembly,u-bolt, Leaf Spring To Axle Recall | Mar 14, 1977

The Involved Vehicles May Have Been Assembled With Improperly Manufactured Front Spring U-bolts Used To Secure The Front Axle Assembly To The Spring. The Four U-bolts May Experience Cracks And Could Ultimately Break. Should Two U-bolts On The Same Side Of The Vehicle Break, The Front Axle Would Not Be Retained Securely.. Follwoing Is The Summary Of Corrective Actions Taken: All Suspect U-bolts Will Be Replaced By The Dealer, Free Of Charge.
vehicle Description: Medium Trucks And Buses.system: Suspension; Front Spring U-bolt.consequences Of Defect: This Failure Could Occur Without Prior Warning Andcould Cause Loss Of Vehicle Control And An Accident.

This recall was issued on Mar 14, 1977 for 1977 Ford B7000, manufactured by FORD MOTOR COMPANY, in response to Suspension,front,springs,leaf Spring Assembly,u-bolt, Leaf Spring To Axle problems.

1986 Ford B7000 Recall | Buses May Have Been Built With An Incorrect Type Of Steel Tubing In The Intermediate Rear Service Brake Lines Which May Leak Or Break

1986 Ford B7000 Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings Recall | July 11, 1986

Buses May Have Been Built With An Incorrect Type Of Steel Tubing In The Intermediate Rear Service Brake Lines Which May Leak Or Break During Application Of The Brakes. Consequence Of Defect: If A Brake Line Leaked, Rear Brakes Could Quit Working, Increasing Stopping Distance, Which Could Result In A Crash.. Follwoing Is The Summary Of Corrective Actions Taken: Replace Brake Lines.
system: Hydraulic Brake Tubing. Vehicle Description: Heavy-duty Bus Chassis With 255″ Wheelbases And Hydraulicbrakes.

This recall was issued on July 11, 1986 for 1986 Ford B7000, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings problems.