1971 Ford C600 Recall |

1971 Ford C600 Service Brakes, Hydraulic,power Assist,vacuum Recall | Feb 19, 1971

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No H-73.f,b,c,ln-500-750, 6000-7000 & C-l 800- 900 Seriestrucks Equipped With Frame Mounted Brake Booster. Possibility That Improperlymachined Brake Booster May Have Be En Installed, Which Could Result Ininsufficient Seal At Hydra Ulic End Cap.if This Condition Exists, Hydraulicbrake Fluidleaks Would Gradually Deplete Brake Fluid Reserve Resulting I Ncomplete Loss Of Hydraulic Brake System On Vehicles Equippedwithsinglehydraulic Seal Where Necessary).necessary.eabl

This recall was issued on Feb 19, 1971 for 1971 Ford C600, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,power Assist,vacuum problems.

1974 Ford C600 Recall |

1974 Ford C600 Fuel System, Gasoline,carburetor System Recall | Feb 25, 1974

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No 116.trucks.bus Chassis M-450,500 Motor Home Chassis.possibilitythat The Carburetor Throttle Lever May Fracture And Separate Fromthe Throttle Shaft And Result In Loss Of Accelerator Pedal Control Without Priorwarning To The Driver.should This Condition Occur, The Throttle Plate Canassume A Position Within The Idle To Wide Open Throttle Range.(correct Byinspecting And Replacing With A Redesigned Lever Assembly).

This recall was issued on Feb 25, 1974 for 1974 Ford C600, manufactured by FORD MOTOR COMPANY, in response to Fuel System, Gasoline,carburetor System problems.

1978 Ford C600 Recall | The Engine Cooling Fan Blades May Crack From Vibrational Motion. Blade Fragments May Separate Without Prior Warning From A Cracked Blade While The Vehicle Is In Operation.

1978 Ford C600 Engine And Engine Cooling,cooling System,fan Recall | Jan 10, 1978

The Engine Cooling Fan Blades May Crack From Vibrational Motion. Blade Fragments May Separate Without Prior Warning From A Cracked Blade While The Vehicle Is In Operation.. Follwoing Is The Summary Of Corrective Actions Taken: The Dealer Will Replace Existing Fan With A Service Fan Of A New Design, At No Charge.
vehicle Description: Trucks Equipped With 361, 389 Or 391 Ft Engines And At-540transmissions.system: Engine; Engine Cooling Fan Blades.consequences Of Defect: The Blade Fragments Could Damage Engine Components And,if The Hood Is Open While The Engine Is Running, The Fragments Could Fly Outand Cause Injury To Persons In The Vicinity.note: The Engine Should Not Be Operated With The Hood Open Until The Engine Fanhas Been Replaced.

This recall was issued on Jan 10, 1978 for 1978 Ford C600, manufactured by FORD MOTOR COMPANY, in response to Engine And Engine Cooling,cooling System,fan problems.

1983 Ford C600 Recall | Cracks May Develop In The Spider Member Of Seven Blade Fans Due To Vibrations Of Greater Severity Than Anticipated. The Cracks May Progress To The Point Of Fracture And Allow Portions Of The Spider

1983 Ford C600 Engine And Engine Cooling,cooling System,fan Recall | Dec 28, 1983

Cracks May Develop In The Spider Member Of Seven Blade Fans Due To Vibrations Of Greater Severity Than Anticipated. The Cracks May Progress To The Point Of Fracture And Allow Portions Of The Spider Arms And Attached Blades To Separate.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Replace The Fan With One Of An Improved Design.
vehicle Description: Heavy Trucks Equipped With Caterpiller 3208 Or Detroitdiesel 8.2 Liter Engines.system: Engine And Engine Cooling; Cooling Fan.consequences Of Defect: High Speed Metal Fragments From A Rotating Fan Maycause Damage In The Engine Compartment. If The Cab Is Raised At The Time Offracture, There May Be Serious Injury To Nearby Persons.

This recall was issued on Dec 28, 1983 for 1983 Ford C600, manufactured by FORD MOTOR COMPANY, in response to Engine And Engine Cooling,cooling System,fan problems.

1984 Ford C600 Recall | Damage To Cotter Pin During Assembly Or From Tilting Cab For Service Could Cause Brake Linkage Separation.

1984 Ford C600 Service Brakes, Hydraulic,pedals And Linkages Recall | Mar 26, 1984

Damage To Cotter Pin During Assembly Or From Tilting Cab For Service Could Cause Brake Linkage Separation.. Follwoing Is The Summary Of Corrective Actions Taken: Missing, Worn, Or Partially Sheared Cotter Pins Will Be Replaced.
vehicle Description: Heavy Trucks Equipped With Hydraulic Brakes.system: Service Brakes; Hydraulic Brake System Linkage.consequences Of Defect: Brake Linkage Separation Results In Loss Of Brakingcapability Without Warning And Possible Vehicle Crash.note: Vehicle Should Not Be Operated Until The Linkage Has Been Inspected.

This recall was issued on Mar 26, 1984 for 1984 Ford C600, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,pedals And Linkages problems.

1985 Ford C600 Recall | The Hydraulic Parking Brake Control Valve May Inadvertently Activate Due To Momentary Pressure Disruptions Within The System And Cause The Parking

1985 Ford C600 Parking Brake,driveline,air Recall | Dec 20, 1985

The Hydraulic Parking Brake Control Valve May Inadvertently Activate Due To Momentary Pressure Disruptions Within The System And Cause The Parking Brake To Be Applied, Stopping Or Slowing The Truck Unexpectedly. Consequence Of Defect: This Unexpected Stopping Or Slowing Of The Truck May Increase The Risk Of A Rear End Collision Since The Brake (stop) Lights Are Not Activated. Also, On Certain Road Conditions This Occurrence May Result In Loss Of Vehicle Control Which Would Lead To An Accident.. Follwoing Is The Summary Of Corrective Actions Taken: Replace The Push-pull Type Brake Control Valve With New Over-center Cam Type Valves.
system: Hydraulic Parking Brake Control Valve.vehicle Description: Medium And Heavy Truck And Bus Chassis Equipped With Hydraulic Brakes.

This recall was issued on Dec 20, 1985 for 1985 Ford C600, manufactured by FORD MOTOR COMPANY, in response to Parking Brake,driveline,air problems.