2007 Ford F100 Recall | Certain Federal-mogul Aftermarket Fuel Pumps Sold Under The Brand Names Of Carter,

2007 Ford F100 Fuel System, Gasoline,delivery,fuel Pump Recall | Aug 27, 2007

Certain Federal-mogul Aftermarket Fuel Pumps Sold Under The Brand Names Of Carter, Accuflow, Napa, Truflow, Parts Depo, And Parts Master, Shipped Between August 2006 And July 2007 For Use On The Vehicles Listed Above. The Fuel Pump Diaphragm In Certain Production Runs May Have Been Improperly Installed Or Inadequately Tested Which May Cause The Fuel Pump To Leak.

A Leaking Fuel Pump Could Create A Vehicle Fire Hazard.

Summary Of Corrective Actions Taken: Federal-mogul Will Notify Owners And Replace The Defective Fuel Pumps Free Of Charge. The Recall Began On October 15, 2007. Owners Can Contact Federal-mogul At 248-354-7700.

This Recall Only Pertains To Aftermarket Carter, Napa, Accuflow, Tru Flow, Parts Master, And Parts Depot Brand Fuel Pumps And Has No Relation To Any Original Equipment Installed On The Listed Motor Vehicles.customers May Contact The National Highway Traffic Safety Administration’s Vehicle Safety Hotline At 1-888-327-4236 (tty: 1-800-424-9153); Or Go To Http://www.safercar.gov.

This recall was issued on Aug 27, 2007 for 2007 Ford F100, manufactured by FEDERAL-MOGUL CORPORATION, in response to Fuel System, Gasoline,delivery,fuel Pump problems.

1979 Ford F100 Recall | The Wheel Assembly May Contain Substandard Welds In The Area Where The Disc Is Attached To The Rim. As A Result, Cracks Can Form In The Wheel Assembly, Causing Air Loss And

1979 Ford F100 Wheels Recall | Aug 07, 1979

The Wheel Assembly May Contain Substandard Welds In The Area Where The Disc Is Attached To The Rim. As A Result, Cracks Can Form In The Wheel Assembly, Causing Air Loss And An Underinflated Tire.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect And Replace Any Defective Wheels Without Charge To Owner.
vehicle Description: Light Trucks Equipped With 15 X 5.5k Wheel Assemblies.system: Wheels; Wheel Assembly.consequences Of Defect: Low Tire Inflation Pressures Could Cause Loss Ofvehicle Control And An Accident. Also, If The Spot Welds Fail, The Rim And Tirecould Separate From The Wheel Disc, With Consequent Loss Of Control Andaccident.

This recall was issued on Aug 07, 1979 for 1979 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Wheels problems.

1983 Ford F100 Recall | The Parking Gear May Not Engage, Even Though The Gear Shift Lever Is Placed In The “park” Position. This Occurs If The Linkage Inside The Transmission That Actuates The Park Gear Was Improperly

1983 Ford F100 Power Train,automatic Transmission Recall | Mar 07, 1983

The Parking Gear May Not Engage, Even Though The Gear Shift Lever Is Placed In The “park” Position. This Occurs If The Linkage Inside The Transmission That Actuates The Park Gear Was Improperly Manufactured. A Pin That Retains Components On A Linkage (actuating) Rod Could Break And The Linkage May Not Engage The Parking Gear.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect And, If Necessary, Replace The Parking Pawl Actuating Rod Assembly.
vehicle Description: Passenger Vehicles Equipped With Automatic Overdrivetransmissions.system: Power Train; Transmission, Parking Pawl Actuating Assembly.consequences Of Defect: If The Parking Brake Is Not Applied And The Parkinggear Does Not Engage, Unexpected Vehicle Movement Could Cause An Accident Andpersonal Injury.note: Drivers Should Always Apply The Parking Brake Whenever Leaving Thevehicle.

This recall was issued on Mar 07, 1983 for 1983 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Power Train,automatic Transmission problems.

1979 Ford F100 Recall | The Parking Pawl Actuating Rod In The Transmission May Have An Insufficient Or Cracked Weld. This Can Cause The Park Cam End To Separate From The Rod Itself, Preventing The Parking Pawl From

1979 Ford F100 Power Train,automatic Transmission,lever And Linkage,column Shift Recall | Dec 18, 1979

The Parking Pawl Actuating Rod In The Transmission May Have An Insufficient Or Cracked Weld. This Can Cause The Park Cam End To Separate From The Rod Itself, Preventing The Parking Pawl From Engaging The Parking Gear When The Selector Is Placed In The Park Position.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Replace The Defective Parking Pawl Actuating Rod Free Of Charge.
vehicle Description: Light Trucks.system: Power Train; Park Actuating Rod.consequences Of Defect: If Vehicle Is Parked On An Incline And The Emergencybrake Is Not Engaged, The Vehicle Could Roll Free, Possibly Causing Injury Tobystanders And Personal Property.

This recall was issued on Dec 18, 1979 for 1979 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Power Train,automatic Transmission,lever And Linkage,column Shift problems.

1966 Ford F100 Recall |

1966 Ford F100 Service Brakes, Hydraulic,foundation Components,master Cylinder Recall | Oct 20, 1966

. Follwoing Is The Summary Of Corrective Actions Taken:
possibility That The Brake Master Cylinder Contains A Brittle Pushrod Retaining Ring.if This Ring Breaks, It Could Permit The Pushrod To Become Disengaged From The Master Cylinder, Rendering The Hydraulic Brake System Inoperative.(add Bumper Stop To Prevent Disengagement.)

This recall was issued on Oct 20, 1966 for 1966 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,foundation Components,master Cylinder problems.

1972 Ford F100 Recall |

1972 Ford F100 Suspension,front,wheel Bearing Recall | Aug 24, 1972

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Truck Campaign No H/o-4c.4×2 Trucks.possibility That Vehicles Wereassembled With Over-tightened Front Wheel Bearing Nut.incorrect Torquingprocedure Could Preload Wheel Bearings, Causing Them To Seize On Spindle Stem.spindle Stem Could Break, Allowing Wheel To Disengage Without Warning.(correct By Inspecting And Replaceing Bearing And Spindle Where Necessary.)

This recall was issued on Aug 24, 1972 for 1972 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Suspension,front,wheel Bearing problems.

1970 Ford F100 Recall |

1970 Ford F100 Tires,tread/belt Recall | Sept 25, 1970

. Follwoing Is The Summary Of Corrective Actions Taken:
possibility That Goodyear Tires Size G-78-15-b Glass Belted Were In-advertently Manufactured With Inadequate Thickness Of Inner Tread Coveringfiberglass Belt.this Could Result In Tread Separation And Cause Severevehicle Vibration.(correct By Replacing With New Tire.)

This recall was issued on Sept 25, 1970 for 1970 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Tires,tread/belt problems.

1971 Ford F100 Recall |

1971 Ford F100 Seat Belts,front,anchorage Recall | Nov 22, 1971

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No H-1b.light Trucks Built Between Aug.16, 1 971, And Oct.14, 1971,f-100 Thur F-350 Series.possibilitythat Seat Belt And Shoulderharness Attaching Bolts Were Impro Perly Processed During Heat Treating Andplating Operations. If Condition Exists, May Cause Bolts To Be Susceptible Tohydr Ogen Embrittlement Fracturing After Installation.(correct Byinspectingand Replacing With Properly Heat Treated Bolts.)

This recall was issued on Nov 22, 1971 for 1971 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Seat Belts,front,anchorage problems.

1977 Ford F100 Recall | On The Involved Vehicles, The Park Actuation Support Plates Are Defective Due To Their Susceptibility To Cracking Due To Improper Heat Treatment During Manufacture. As A Result, Fragments From A Broken Plate

1977 Ford F100 Power Train,automatic Transmission,lever And Linkage,column Shift Recall | Oct 25, 1977

On The Involved Vehicles, The Park Actuation Support Plates Are Defective Due To Their Susceptibility To Cracking Due To Improper Heat Treatment During Manufacture. As A Result, Fragments From A Broken Plate Can Become Lodged In The Transmission Parking Pawl Mechanism. This Could Prevent The Transmission Parking Pawl From Engaging When The Selector Lever Is Placed In The “park” Position, Or Prevent The Pawl From Being Disengaged From The Park Gear.. Follwoing Is The Summary Of Corrective Actions Taken: The Dealer Will Replace The Park Actuation Cam Support Plates, Free Of Charge, On All Affected Vehicles.
vehicle Description: Passenger Vehicles And Light Trucks Equipped With C-6automatic Transmissions.system: Power Train; Park Actuation Gear Support Plates.consequences Of Defect: If The Vehicle Is Placed In The Park Mode Without Theparking Brake Engaged, The Parking Pawl May Not Engage The “park” Gear And Thevehicle Would Be Allowed To Roll Free Causing Property Damage And Personalinjuries.

This recall was issued on Oct 25, 1977 for 1977 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Power Train,automatic Transmission,lever And Linkage,column Shift problems.

1977 Ford F100 Recall | On The Involved Vehicles, Leakage May Occur At The Threaded Carburetor-to-fuel Filter Connection On The Suspect Carburetors. This Is Due To An Improperly Machined Carburetor Fuel Inlet Connection.

1977 Ford F100 Fuel System, Gasoline,carburetor System Recall | Nov 15, 1977

On The Involved Vehicles, Leakage May Occur At The Threaded Carburetor-to-fuel Filter Connection On The Suspect Carburetors. This Is Due To An Improperly Machined Carburetor Fuel Inlet Connection.. Follwoing Is The Summary Of Corrective Actions Taken: Dealer Will Inspect And, If Necessary, Will Replace The Carburetor Without Charge To Owner.
vehicle Description: Light Trucks Equipped With 300 Cid Engines.system: Fuel; Carburetor.consequences Of Defect: If An Ignition Source Is Present When Fuel Leakageoccurs, A Fire Could Start And Cause Engine Damage And Serious Injury Tovehicle Occupants.note: Fuel Odors May Indicate A Leak.

This recall was issued on Nov 15, 1977 for 1977 Ford F100, manufactured by FORD MOTOR COMPANY, in response to Fuel System, Gasoline,carburetor System problems.