2007 Ford F700 Recall | Certain Federal-mogul Aftermarket Fuel Pumps Sold Under The Brand Names Of Carter,

2007 Ford F700 Fuel System, Gasoline,delivery,fuel Pump Recall | Aug 27, 2007

Certain Federal-mogul Aftermarket Fuel Pumps Sold Under The Brand Names Of Carter, Accuflow, Napa, Truflow, Parts Depo, And Parts Master, Shipped Between August 2006 And July 2007 For Use On The Vehicles Listed Above. The Fuel Pump Diaphragm In Certain Production Runs May Have Been Improperly Installed Or Inadequately Tested Which May Cause The Fuel Pump To Leak.

A Leaking Fuel Pump Could Create A Vehicle Fire Hazard.

Summary Of Corrective Actions Taken: Federal-mogul Will Notify Owners And Replace The Defective Fuel Pumps Free Of Charge. The Recall Began On October 15, 2007. Owners Can Contact Federal-mogul At 248-354-7700.

This Recall Only Pertains To Aftermarket Carter, Napa, Accuflow, Tru Flow, Parts Master, And Parts Depot Brand Fuel Pumps And Has No Relation To Any Original Equipment Installed On The Listed Motor Vehicles.customers May Contact The National Highway Traffic Safety Administration’s Vehicle Safety Hotline At 1-888-327-4236 (tty: 1-800-424-9153); Or Go To Http://www.safercar.gov.

This recall was issued on Aug 27, 2007 for 2007 Ford F700, manufactured by FEDERAL-MOGUL CORPORATION, in response to Fuel System, Gasoline,delivery,fuel Pump problems.

1981 Ford F700 Recall | The Involved Vehicles Were Assembled With The Left Front Brake Tube Retaining Clip Missing. The Absence Of A Retaining Clip May Allow The Brake Tube To Rub Against The Shock Absorber, Causing Wear

1981 Ford F700 Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings Recall | July 17, 1981

The Involved Vehicles Were Assembled With The Left Front Brake Tube Retaining Clip Missing. The Absence Of A Retaining Clip May Allow The Brake Tube To Rub Against The Shock Absorber, Causing Wear On The Tube And, Eventually, Loss Of Brake Fluid.. Follwoing Is The Summary Of Corrective Actions Taken: Missing Brake Tube Clips Will Be Installed And Any Chafed Brake Tubes Will Be Replaced.
vehicle Description: School Buses And Trucks Equipped With 8.2 Liter Dieselengines And Hydraulic Brakes.system: Service Brakes; Left Hand Front Brake Tube Retaining Clip.consequences Of Defect: On Vehicles Equipped With Single System Hydraulicbrakes, Sufficient Loss Of Brake Fluid Could Result In Loss Of Service Brakingcapability. This Could Cause A Loss Of Vehicle Control And An Accident. Onvehicles Equipped With Split System Hydraulic Brakes, Loss Of Brake Fluid Inthe Hydraulic Circuit Of One System Could Cause Loss Of Service Braking In Theaffected System. Braking Distance Would Be Increased, Possibly Resulting In Anaccident.

This recall was issued on July 17, 1981 for 1981 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings problems.

1981 Ford F700 Recall | The Primary Circuit Connection, Which Provides Primary Electrical Power To The Engine, Could Deteriorate Due To High Current Draw Produced By Builder-installed Equipment.

1981 Ford F700 Electrical System,wiring Recall | June 15, 1981

The Primary Circuit Connection, Which Provides Primary Electrical Power To The Engine, Could Deteriorate Due To High Current Draw Produced By Builder-installed Equipment.. Follwoing Is The Summary Of Corrective Actions Taken: The Main Cab Wiring Harness Electrical Connector Will Be Modified To Eliminate Deterioration At No Charge To Owner.
vehicle Description: School Buses.system: Electrical; Primary Circuit Connector.consequences Of Defect: Depending On The Degree Of Deterioration Present,intermittent Or Complete Loss Of All Vehicle Electrical Power Could Result.this Would Cause The Engine To Stop Running And Power Steering Assist And Powerassist For Hydraulic Brakes Would Be Lost, If The Vehicle Is So Equipped. Thesefailures Could Occur Without Warning, Possibly Resulting In An Accident.note: Vehicle Should Be Removed From Service Until The Problem Is Corrected.

This recall was issued on June 15, 1981 for 1981 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Electrical System,wiring problems.

1983 Ford F700 Recall | On The Affected Vehicles, The Wiring Assembly To The Floor Mounted Headlamp Dimmer Switch May Be Too Tight; Should Wires Disconnect, The Headlights Will Not Operate.

1983 Ford F700 Electrical System,wiring Recall | Feb 15, 1983

On The Affected Vehicles, The Wiring Assembly To The Floor Mounted Headlamp Dimmer Switch May Be Too Tight; Should Wires Disconnect, The Headlights Will Not Operate.. Follwoing Is The Summary Of Corrective Actions Taken: The Dealer Will Modify The Dimmer Switch Wiring With A Wire Extension Assembly At No Charge To Owner.
vehicle Description: Medium Trucks, Heavy Trucks And Bus Chassis.system: Lighting And Communications; Headlamp Dimmer Switch Wiring Harness.consequences Of Defect: Driver Foot Pressure On Or Above The Dimmer Switch Mayresult In Disconnection Of The Wires And Subsequent Loss Of Headlampillumination. Headlamp Failure Could Cause A Vehicle Crash.

This recall was issued on Feb 15, 1983 for 1983 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Electrical System,wiring problems.

1968 Ford F700 Recall |

1968 Ford F700 Steering Recall | Apr 02, 1968

. Follwoing Is The Summary Of Corrective Actions Taken:
possibility Failure Of Rivets Used For Attaching The Front Spring Rear Hanger Bracket To The Frame.rivet Failure Would Allow The Bracket To Separate From The Frame Imposing Severe Loads At The Front Bracket.should The Spring Disengage From The Front Bracket The Axle Will Shift And Loss Of Steering Control Could Result.also, There Is A Pos- Sibility Of Misassembly Or Mis-alignment Of Certain Components In The Power Steering System.failure To Correct This Condition, If Present, Also Could Result In Loss Of Steering Control.(correct By In- Stalling New Rivets And Power Steering Components If Necessary.)

This recall was issued on Apr 02, 1968 for 1968 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Steering problems.

1980 Ford F700 Recall | On Certain Vehicles, Two Fuel Line Brackets Were Incorrectly Positioned, Allowing The Fuel Line To Come Into Contact With The Left Hand Front Brake Jounce Hose. Contact With The Fuel Line,

1980 Ford F700 Fuel System, Gasoline,delivery,hoses, Lines/piping, And Fittings Recall | July 14, 1980

On Certain Vehicles, Two Fuel Line Brackets Were Incorrectly Positioned, Allowing The Fuel Line To Come Into Contact With The Left Hand Front Brake Jounce Hose. Contact With The Fuel Line, Which Has A Metal Outer Shield, Could Cause Chafing Of The Brake Hose.. Follwoing Is The Summary Of Corrective Actions Taken: Owners Will Be Provided With Instructions For Repositioning The Brackets To Reroute The Fuel Line. The Left-hand Brake Jounce Hose Will Also Be Replaced If Chafing Has Occurred.
vehicle Description: Trucks.system: Fuel; Fuel Line Fittings.consequences Of Defect: Continued Chafing Of The Brake Hose Could Lead To Lossof Brake Fluid, Loss Of Braking Capability, And An Accident.

This recall was issued on July 14, 1980 for 1980 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Fuel System, Gasoline,delivery,hoses, Lines/piping, And Fittings problems.

1971 Ford F700 Recall |

1971 Ford F700 Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings Recall | Feb 19, 1971

. Follwoing Is The Summary Of Corrective Actions Taken:
trucks And Buses Equipped With Split Hydraulic Brake Systems.possibility Thatbrake Tubes May Have Been Routed So That Ther E Is Insufficient Clearancebetween Steel Brake Line And Trans Mission Housing. This Could Cause Brake Lineto Be Penetratedby Chafing Action, Resulting In Noticeable Reduction Invehicl E Braking Ability.(correct By Replacing And Rerouting Wherenecessary.)

This recall was issued on Feb 19, 1971 for 1971 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,foundation Components,hoses, Lines/piping, And Fittings problems.

1967 Ford F700 Recall |

1967 Ford F700 Steering Recall | June 16, 1967

. Follwoing Is The Summary Of Corrective Actions Taken:
possibility That Steering Components May Be Subject To Possible Damage Under Poor Road Conditions With Severe Chuckholes And Especially At High Mileages.the First Indication Of Any Problem Would Be Marked Increase In Steering Efforts Which Could Increase The Possibility Of Failure To Critical Steering Components.(inspect And Replace Steering Components With New Design.)

This recall was issued on June 16, 1967 for 1967 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Steering problems.

1975 Ford F700 Recall |

1975 Ford F700 Service Brakes, Hydraulic,pedals And Linkages Recall | May 12, 1975

. Follwoing Is The Summary Of Corrective Actions Taken:
ford Campaign No 158.trucks And Truck Chassis Cabs, Bus Chassis Equipped Withhydraulic Brakes.possibility That The Hydraulic Brakes May Have Beenassembled With Brake Pedal Push Rod Pins Made From An Incorrect Steel.weldingof Such Push Rod Pins To The Brake Pedal Assembly Causes The Area Adjacent Tothe Weld To Become Brittle And May Result In Pin Fracture And Separation Duringa High Pedal Effort Stop.should This Occur, The Service Brakes Could Not Beapplied.(correct By Inspecting And Installing Pins Made Of Correct Steelwhere Necessary).

This recall was issued on May 12, 1975 for 1975 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Service Brakes, Hydraulic,pedals And Linkages problems.

1969 Ford F700 Recall |

1969 Ford F700 Latches/locks/linkages,doors,latch Recall | May 07, 1969

. Follwoing Is The Summary Of Corrective Actions Taken:
possibility That Right Door And Cargo Door Latches May Have Improperly Madepart And, Under Certain Conditions, May Not Secure The Door Unless Locked Withkey Or Lock Button.(correct By Inspect- Ing And Replacing Door Latches Whennecessary.)

This recall was issued on May 07, 1969 for 1969 Ford F700, manufactured by FORD MOTOR COMPANY, in response to Latches/locks/linkages,doors,latch problems.